plesecrets.blogg.se - Debug android studio device

Ensure that the Developer options switch (upper-right) is turned on.

Select on the Back button and you will see the Developer options menu under Settings, and select Developer options.

Under Developer option, tap on USB Debugging, select USB Debugging to enable it.

Home > Back to Settings, scroll down and tap on Developer option.

Tap Build Number seven times (After tapping seven times on it, you will get a message on your screen that You are now a developer.).

If presented with Allow USB debugging, tap OK. Tap USB debugging to enable or disable.ĥ.

From the Allow development settings screen, tap OK.Ĥ. Ensure the Developer options switch (located at the top) is turned on. Click "tethering & networks", enable the "USB tethering" option.Ģ.Go to Settings > Networks, find tethering & networks under "Connectivity".Otherwise, please follow the steps below: Note: please also make sure you have enabled the " USB tethering " option on your LG device. If presented with "Allow USB debugging?" screen, tap OK.Ensure the Developer options switch is turned on.If presented with a Warning screen, tap OK to continue. Settings Settings icon > Developer options.

Then you have successfully enabled Developer options. If you are having issues finding the USB Debugging option in your child's settings, please find your child's device in the chart below, and follow its associated instructions, to enable USB debugging: If your Android device is not correctly detected by RAD Studio or the system Device Manager, follow the steps above to verify that USB debugging is enabled.įor general information about development setup for Android devices, see the Android documentation." USB Debugging" must be enabled on your child's device so that OurPact can be installed to your child's device settings. If you accidentally click Cancel, disconnect your device from your PC and connect it back to make the dialog show up again on your device. If you are running Android 4.2.2 or later, you may see the following dialog when you connect your device to your PC running RAD Studio:Ĭlick OK to allow USB debugging on your PC. For more information, see the Amazon documentation. Select Settings > Security and set Enable ADB to On. Tip: You might also want to enable the Stay awake option, to prevent your Android device from sleeping while plugged into the USB port.įor more information, see Unlocking Jelly Bean and Higher Devices

Tap the Build number seven times to make Settings > Developer options available.

On the device, go to Settings > About.

The steps to enable USB debugging depend on the version of Android running on the target device, as indicated in the following table:Įnable the USB Debugging option under Settings > Developer options.įor Android 4.2 and newer, Developer options is hidden by default use the following steps: